mikrotik router default settings using the console

ok after we had discussed about how to install the proxy on the other post reply, well we just bsa router how to use the console settings

1  The first step Setting IP Address, Gateway & Name servers

ip address add address={ ip address / netmask }
interface={ nama interface, ether1 atau ether2 bila ada 2 network
card }

after already done everything you can see if the IP that you enter is already there or not, you can use the “IP ADDRESS PRINT” command and then you enter

2  Gateway settings

Form of configuration commands

ip route add gateway={ ip gateway }
Example configuration

Ip route print command is to see the routing table.

This same command as the command function which has been

3 DNS settings

ip dns set primary-dns={ dns utama }
seconday-dns={ dns ke dua }

Ip command print is to see the result of dns configuration

Ip command print is to see the result of dns configuration.

4 then we are setting a firewall

ip firewall nat add chain=srcnat action=masquerade

after configuration has finished all of our ping test towww.yahoo.com
If the ping replay is already finished and already in use

probably quite a few just from me, and good luck